Stainless Steel Pressure Transducers

0-500, 0-1000, 0-2500 psi depending on the unit you select.

Input: 5 volts

Output: 0.5V – 4.5V linear voltage output

For gases and light fluids

Accuracy: within 1.5% of reading (full scale).

Current draw: less than 4 mA.

Burst (maximum) pressure: minimum 3000 psi.

Thread: 1/8”-27 NPT. 

Weight: 59 grams

Wiring connector: water resistant quick disconnect with silicone gasket.  Mating connector and 7" wire harness (pigtail) is included.

Wiring: Red for +5V.  Black for ground.  Blue for signal output.

Body is 316 Stainless, ceramic pressure chip sensor.

Since the output voltage is not millivolt you do not need an amplifier with this unit when using our data aquisition units.